ProScan PLT8015-K User Manual download pdf (Page 5)

Setting up for the first time

Charging your device

For first-time use, you need to charge the device for ten hours.

After that you can recharge the device as needed.

Connect the DC-in jack to your device and plug the AC adapter into any AC outlet.

TIPS:

1. This device adopts built-in polymer battery. Only the specified charger should be used.

2. It is normal for the devices surface to become warm during charging or long

periods of use. All devices are factory tested before release.

3. If you do not use this set for a long time, please charge/release it once

one month to avoid deep discharge. The damage caused by battery over-consuming is not included in the warranty.

Battery Saving

To save battery running life, please see below key points. With below suggestions, battery can run longer time after fully charged each time.

1. When device is not in use, press power button once to go to sleep mode.

2. Shut down the applications when not in use.

3. Turn off WLAN when not in use

4. Shut off application sync selection

5. Set a shorter time for display backlight

6. Reduce brightness of display

1 2 3 4 5 6 7 8 9 10 ... 22 23

No comments

ProScan PLT8015-K User Manual Page 5